000
| 02074cam 2200337zi 4500 |
---|
001 | 9.928584 |
---|
003 | CaOODSP |
---|
005 | 20231012114728 |
---|
006 | m o d f |
---|
007 | cr |n||||||||| |
---|
008 | 231012e197403##onco ob f000 0 eng d |
---|
040 | |aCaOODSP|beng|erda|cCaOODSP |
---|
043 | |an-cn--- |
---|
086 | 1 |aA58-4/430E-PDF |
---|
100 | 1 |aHergert, G.B., |eauthor. |
---|
245 | 10|aEvaluation of the craftsman divider for applications on experimental plot seeders / |cG.B. Hergert. |
---|
264 | 1|a[Ottawa] : |bEngineering Research Service, |cMarch 1974. |
---|
300 | |a1 online resource (5 pages) : |bphotographs. |
---|
336 | |atext|btxt|2rdacontent |
---|
337 | |acomputer|bc|2rdamedia |
---|
338 | |aonline resource|bcr|2rdacarrier |
---|
490 | 1 |aContribution ; |vno. 430. |
---|
500 | |aCaption title. |
---|
500 | |a"Report number: 7233-2." |
---|
504 | |aIncludes bibliographical references (page 3). |
---|
520 | |a"A new divider has been developed by University of Manitoba Crop Science Department and Craftsman Machine Co. The divider differs from previous models in that there are no power requirements, and the sample to be divided passes through the divider before the cone dispensers. This allows a single sample to be divided in the field, but eliminates some of the problems previously encountered with dividers such as excessive time lag between seed dispensing and ejection by the divider, the need to keep the divider level to maintain accuracy while traversing the plot, and danger of plugging the small orifice required for spinning element dividers. The divider was tested for accuracy of division and repetition, and is reported here"--Page [1]. |
---|
650 | 0|aSowing|xEquipment and supplies. |
---|
650 | 6|aSemis|xAppareils et matériel. |
---|
710 | 1 |aCanada. |bAgriculture Canada. |bEngineering Research Service, |eissuing body. |
---|
830 | #0|aContribution (Canada. Agriculture Canada. Engineering Research Service)|vno. 430.|w(CaOODSP)9.921188 |
---|
856 | 40|qPDF|s7.42 MB|uhttps://publications.gc.ca/collections/collection_2023/aac-aafc/A58-4-430-eng.pdf |
---|